1. Hey All! Lately there has been more and more scammers on the forum board. They register and replies to members requests for guns and/or parts or other things. The reply contains a gmail or hotmail address or similar ”anonymous” email addresses which they want you to reply to. DO NOT ANSWER ANY STRANGE MESSAGES! They often state something like this: ”Hello! Saw your post about purchasing a stock for a Safari. KnuckleheadBob has one. Email him at: [email protected]” If you receive any strange messages: Check the status of whoever message you. If they have no posts and signed up the same day or very recently, stay away. Same goes for other members they might refer to. Check them too and if they are long standing members, PM them and ask if the message is legit. Most likely it’s not. Then use the report function in each message or post so I can kick them out! Beware of anything that might seem fishy! And again, for all of you who registered your personal name as username, please contact me so I can change it to a more anonymous username. You’d be surprised of how much one can find out about a person from just a username on a forum such ad our! All the best! And be safe! Jim
    Dismiss Notice

Sako P94s single short mags

Discussion in 'Sako Rimfires and Small Action Rifles' started by xb40, Mar 11, 2021.

  1. xb40

    xb40 Member

    Messages:
    21
    Likes Received:
    3
    Country Flag:
    USA
    State/Region:
    US Alabama
    Long story short. Along with others who are shooting P94’s, several members at Rimfire Central have a
    member who has the capability of printing mags using his 3D printer. He needs to use a P94s to enable him to make the single shot magazines. He lives in the Dallas/Fort Worth area. So far we haven’t located one of our members in the Dallas/Fort Worth area. If anyone lives in the area and would like to assist with the project, let me know and I will connect you with the Rimfire member, and hopefully we can have some single shots for our P949’s. Give me a PM, we can go from there. Thanks
    Larry

     

Share This Page