I have come across a TRG 22 barreled action in somewhat rough shape and am working to nurse it back to health. One question I cannot seem to find the answer to online is what are the action screw specs for the three screws. I need to find out not only the torque specs, but also the screw sizes. Thank you so much for your help. N.
-
Hey All! Lately there has been more and more scammers on the forum board. They register and replies to members requests for guns and/or parts or other things. The reply contains a gmail or hotmail address or similar ”anonymous” email addresses which they want you to reply to. DO NOT ANSWER ANY STRANGE MESSAGES! They often state something like this: ”Hello! Saw your post about purchasing a stock for a Safari. KnuckleheadBob has one. Email him at: [email protected]” If you receive any strange messages: Check the status of whoever message you. If they have no posts and signed up the same day or very recently, stay away. Same goes for other members they might refer to. Check them too and if they are long standing members, PM them and ask if the message is legit. Most likely it’s not. Then use the report function in each message or post so I can kick them out! Beware of anything that might seem fishy! And again, for all of you who registered your personal name as username, please contact me so I can change it to a more anonymous username. You’d be surprised of how much one can find out about a person from just a username on a forum such ad our! All the best! And be safe! Jim
TRG 22 Thread Specs
- Thread starter norbert
- Start date
Sako Collectors Club Discussion Forum
CerebralDistortion
Well-Known Member
Good find!
The screws are metric standard M6.
Length. Just cut them to size.
Torque 8-10 Nm.
Best I can do. Let's see if someone else chimes in.
What stock will you be using?
The screws are metric standard M6.
Length. Just cut them to size.
Torque 8-10 Nm.
Best I can do. Let's see if someone else chimes in.
What stock will you be using?
CerebralDistortion
Well-Known Member
The KRG W3 is all you need. Get a SOTIC barrel and barrel nut while you're at it
Unless, of course, you can source the missing original parts cheaper.
If you haven't seen this:
https://www.snipershide.com/shooting/threads/sako-trg-trg-s-m995-thread-sticky.6260371/
It might be worth looking in to.
Good luck building your rifle!
Oh, and this:
https://kineticresearchgroup.com/download/7043/
Action screw specs from the above:
M6x12 2 pcs and M6x30 1 pcs.
Unless, of course, you can source the missing original parts cheaper.
If you haven't seen this:
https://www.snipershide.com/shooting/threads/sako-trg-trg-s-m995-thread-sticky.6260371/
It might be worth looking in to.
Good luck building your rifle!
Oh, and this:
https://kineticresearchgroup.com/download/7043/
Action screw specs from the above:
M6x12 2 pcs and M6x30 1 pcs.
Last edited:
